Estimate Cement Quantity for a Nominal Mix

Work out a planning quantity of cement from a finished concrete volume and a nominal mix ratio, and see how US and UK/EU product names differ — cement, premixed concrete, ballast, and ready-mix are not interchangeable.

Cement is not the same as concrete

Cement is the binder (commonly Portland cement, or a cement type such as CEM I / CEM II in UK and EU designations). Concrete is the mixed material: cement, fine aggregate (sand), coarse aggregate (gravel or crushed stone), and water, sometimes with admixtures. In everyday US speech, “a bag of cement” is often used when the speaker means a bag of premixed concrete. Those are different products. A 60 lb or 80 lb bag of premix already contains cement and aggregates; a 94 lb bag of Portland cement is cement only and must be mixed with sand and stone (or ballast) to make concrete.

In UK and EU merchant wording you will also see cement (usually 25 kg bags), ballast (a combined sand-and-gravel aggregate sold for site mixing), sharp sand and coarse aggregate sold separately, bagged concrete mix or “ready-to-use concrete” (pre-blended, like US premix), and ready-mixed concrete delivered by truck. This calculator estimates the cement fraction of a nominal site mix, not the number of premix concrete bags — for those, use the bag calculator.

Cement quantity from a nominal mix

Assumptions in this estimate

For a nominal mix written as cement : fine aggregate : coarse aggregate by volume, the cement share of the total parts is cement-parts ÷ (cement + fine + coarse). That share is applied to the waste-adjusted concrete volume. If the 1.54 factor is enabled, the dry volume of ingredients is taken as 1.54 times the finished (wet) concrete volume — a common textbook estimating adjustment for voids when converting a finished volume into dry material volumes. It is an estimating convention, not a laboratory test, and you can turn it off.

Cement mass uses a typical loose bulk density of 1440 kg/m³ (about 90 lb/cu ft). US bag counts use the traditional 94 lb bag, treated as 1 cubic foot of cement. UK/EU bag counts use 25 kg bags (a 20 kg count is also shown). A US 94 lb/cu ft convention is about 1506 kg/m³, which is close to but not identical to 1440 kg/m³, so the two bag conventions are calculated separately from volume rather than forced to match. This is not a mix design and does not specify strength. See the nominal mix ratio chart for the same caution.

Disclaimer: These tools give planning estimates only. Bag yields vary by brand and mix, so check the coverage printed on the bag you buy. Ready-mix quantities, slump, reinforcement, and thickness for any structural, load-bearing, frost-protected, or code-regulated work must follow the project specification, the adopted local building code, and the judgment of a qualified professional. This site is not a structural design service and does not replace a licensed engineer or contractor.