Nominal Concrete Mix Ratios by Volume

A chart of widely cited nominal mixes written as cement : fine aggregate : coarse aggregate by volume — with a clear caution that a nominal ratio is not a structural specification and does not by itself define a strength class.

What a nominal mix ratio means

A nominal mix such as 1 : 2 : 4 is a volume proportion of cement : fine aggregate : coarse aggregate (cement : sand : gravel/stone). It is a traditional way to describe a site mix. It is not a structural specification, not a prescribed strength (not 3,000 psi, not C16/20 or C20/25, not an “M20” grade), and not a substitute for a designed mix or the mix stated on a project’s drawings. Water content, aggregate grading, compaction, and curing all change the result. Use a specified mix, a designed mix, or a manufacturer’s premix when strength or durability is required, and follow local code and a qualified professional.

Common nominal mixes (by volume)

The table lists proportions that are widely cited as common nominal mixes. “Typical use” is informal context only — it is not a permission to use that mix for that job.

Nominal mix (cement : fine : coarse) Cement share of total parts Informal context (not a specification)
1 : 1 : 21 / 4 (25%)A richer traditional mix sometimes used where a stronger nominal mix is wanted. Still not a specified grade.
1 : 1.5 : 31 / 5.5 (18.2%)A common mid-range nominal mix in many textbooks.
1 : 2 : 41 / 7 (14.3%)A very widely quoted general-purpose nominal mix for ordinary mass or non-critical work.
1 : 3 : 61 / 10 (10%)A leaner nominal mix, often mentioned for less demanding mass concrete.
1 : 4 : 81 / 13 (7.7%)A lean nominal mix sometimes mentioned for blinding or very low-demand mass fill — only if the specification allows it.

Some regions loosely associate nominal ratios with strength classes. Those associations are approximate, not universal, and are omitted here on purpose so a ratio is not mistaken for a specified compressive strength. To turn a ratio and a volume into a cement bag count, use the cement calculator.

Caution

Do not treat this chart as a structural specification, a recipe for reinforced members, a frost-protected footing mix, or a substitute for ready-mix ordered to a stated strength and exposure class. If a drawing, engineer, or building official specifies a strength, slump, or exposure class, that specification governs.

Assumptions used on this site (typical planning figures; always confirm the product you buy): 1 cubic yard = 27 cubic feet. Thickness in inches is converted to feet (divide by 12) before multiplying. Typical premix bag yields: 80 lb ≈ 0.60 cu ft (~45 bags/yd³), 60 lb ≈ 0.45 cu ft (~60 bags/yd³), 40 lb ≈ 0.30 cu ft (~90 bags/yd³). A 5–10% waste allowance is common. Ready-mix is often ordered in 0.25 yard increments. Metric bag yields, when used: 25 kg ≈ 0.0125 m³ and 20 kg ≈ 0.010 m³, unless you enter the yield from the bag.

Disclaimer: These tools give planning estimates only. Bag yields vary by brand and mix, so check the coverage printed on the bag you buy. Ready-mix quantities, slump, reinforcement, and thickness for any structural, load-bearing, frost-protected, or code-regulated work must follow the project specification, the adopted local building code, and the judgment of a qualified professional. This site is not a structural design service and does not replace a licensed engineer or contractor.