Calculate Concrete Volume for a Slab

Enter the slab’s length, width, and thickness to get cubic yards and cubic meters, a 0.25 yard ready-mix round-up, and an optional premix bag count based on typical published yields.

Calculator

What this calculator does

This slab tool converts a rectangle’s length, width, and thickness into volume in cubic feet, cubic yards, and cubic meters. Thickness may be entered in inches (the usual US slab input): the calculator divides inches by 12 to obtain feet before multiplying. A waste percentage (default 10%) is applied as a planning allowance, and a ready-mix quantity is rounded up to the next 0.25 cubic yard. An optional bag count uses the typical premix yields listed below — confirm the yield on the bag you purchase.

The formula is the same one used on the volume calculator and the pad calculator. For a trench or wall footing, use the footing calculator instead.

Worked example

A 10 ft by 10 ft slab, 4 inches thick: 10 × 10 × (4 ÷ 12) = 33.33 cu ft = 1.235 cu yd = 0.944 m³. With 10% waste, plan on 1.358 cu yd. In 0.25 yard increments that is often ordered as 1.50 cu yd of ready-mix. Using an 80 lb bag at 0.60 cu ft, 33.33 × 1.10 ÷ 0.60 ≈ 61.1, which rounds up to 62 bags.

Assumptions used on this site (typical planning figures; always confirm the product you buy): 1 cubic yard = 27 cubic feet. Thickness in inches is converted to feet (divide by 12) before multiplying. Typical premix bag yields: 80 lb ≈ 0.60 cu ft (~45 bags/yd³), 60 lb ≈ 0.45 cu ft (~60 bags/yd³), 40 lb ≈ 0.30 cu ft (~90 bags/yd³). A 5–10% waste allowance is common. Ready-mix is often ordered in 0.25 yard increments. Metric bag yields, when used: 25 kg ≈ 0.0125 m³ and 20 kg ≈ 0.010 m³, unless you enter the yield from the bag.

Disclaimer: These tools give planning estimates only. Bag yields vary by brand and mix, so check the coverage printed on the bag you buy. Ready-mix quantities, slump, reinforcement, and thickness for any structural, load-bearing, frost-protected, or code-regulated work must follow the project specification, the adopted local building code, and the judgment of a qualified professional. This site is not a structural design service and does not replace a licensed engineer or contractor.